Double Ended H.P.S. 1000w Lamp

  • 4 Units in Stock
  • Manufactured by: Generic

Double Ended H.P.S. 1000w Lamp is a fantastic high-intensity lamp which is able to produce noticeably bigger, fuller flowers, therefore helping growers achieve far heavier and healthier yields.

As these Double Ended (D.E.) Lamps have a connection either side of the quartz glass jacket, the absence of frame wire eliminates shadows, which helps to improve the optical control. Likewise, they also emit more Ultra Violet and Infra Red light, increasing the potency and essential oils in your plants.

Plus this lamp will maintain its results after multiple growth cycles, saving you plenty of time and money on additional lighting/replacements.

This Double Ended H.P.S. 1000w Lamp provides professional level lighting at a price that will suit even the tightest of budgets. It produces intense light that's particularly heavy in the red areas of the spectrum, generating phenomenal growth rates during the bloom stages, and causing fruits to swell up in size.

  • Initial Lumens: 151,000
  • Colour Temp: 2100K
  • CRI: 30
  • Rated Life: 10,000 Hours

How this Double Ended H.P.S. 1000w Lamp Works.

To use this lamp you’ll need to fit the end with the small square closest to the ballast and fit the other end so that it fits comfortably on the outer edge of the reflector.

Similarly, this lamp is designed for use with a high frequency electronic 1000W ballast and reflector with a special double-ended lamp housing.

It’s important you pick the correct ballast otherwise you’ll overpower and damage your lamp. It produces an excellent spectrum that's particularly intense in the red/orange areas. This promotes rapid growth rates during the bloom phase, causing fruits to swell in size.

How to use the Double Ended H.P.S. 1000w Lamp

Make sure you disconnect the power supply to your fixture prior to removing your old D.E. lamp. Leaving the fixture powered during installation could cause power arcing, fire, electrocution and possibly death.

Turn the power off and get a a clean cloth or put clean gloves on. Insert the lead wires of your D.E. lamp between the slots of a D.E. socket. The pinch (flat side) area of the lamp should be horizontal, not vertical. One end should sit on top of the socket spring while the other rests in front of them. Do not bend the wires!

You can now push gently on the pinch area rest on top of the silver socket springs until the lamp is securely in place. Don’t push too hard as you may break or chip the glass can lead to lamp failure.

Forcefully slide each socket inward until it clicks into place. There should be no gap visible once the socket is closed. An unlocked socket can cause arcing and fire damage.

Always use a clean cloth to hold the glass of the new one. This is because the oils on the skin of your hands (even if they have just been washed) can cause damage to the lamp when it is switched on and becomes hot. Note that the 2 pins on the base of the lamp have different size rings on the ends of the pins.

Warning: When a Double Ended H.P.S. 1000w Lamp is switched on they run extremely hot. As with all H.I.D grow lamps it is necessary to avoid touching the lamp with anything such as fingers or plants as this may cause severe burns or fires.

In particular avoid sprays or liquids coming into contact with the lamp as this may cause premature failure or even an explosion.

PLEASE NOTE: All H.P.S. lamps need to be bedded in as follows: on first illumination lamps need to be run continuously for a minimum of 15-30 minutes (although we would recommend that they are first run for much longer such as several hours). This run-in process allow the metals within the lamp to fuse correctly.

FAILURE TO DO THIS WILL RESULT IN LAMP FAILURE!


This product was added to our catalog on Friday 24 December, 2021.

Back to Top